Patented Maximum Power Point Tracking technology allows Solar Boost 2512i and Solar Boost 2512iX to increase charge current up to 30% or more compared to conventional charge controllers. Dont waste your money by throwing PV power away! Get the power you paid for with a Solar Boost charge controller.
The low cost Solar Boost 2512i provides an advanced fully automatic 3-stage charge control system to ensure the battery is properly and fully charged, resulting in enhanced battery performance with less maintenance. A partial IPN network interface is also included to allow use of the IPN-Remote or IPN-ProRemote displays.
- Output Current Rating 25 Amp maximum, automatic 25 Amp output current limit
- Nominal Battery Voltage 12VDC
- PV Input Voltage 35VDC maximum
- Power Consumption 0.35W Typical standby ?? 1.0W Typical charge on
- Charge Algorithm 3-stage Bulk/Acceptance/Float ?? Charge time in Acceptance fixed at 2 hours (Range 0 10 hours ) (Full charge can be based on net charge current matched to battery amp-hours )
- Acceptance Voltage 14.2VDC Fixed Value (10.0 20.0VDC )
- Float Voltage 13.2VDC Fixed Value (10.0 20.0VDC )
- Power Conversion Efficiency 97% @ 14 Volt 20 Amp Output
- Physical Configuration and Dimensions Open frame construction with conformal coated electronics mounted to rear of 5.3 x 5.3 (13.5cm x 13.5cm) clear anodized aluminum face plate. Electronics extend 1.9 (4.83cm) behind front panel. Mounts into standard 411/16 (11.9cm) square electrical box which is included, Raco p/n 8257 or equivalent.
- Analog Input Accuracy / Range Battery and PV voltmeters, 35.0VDC 0.50% FS Input/Output ammeters, 30.0A 0.50% FS
- Communication IPN Network interface for IPN displays only. Full IPN interface to allow multicontroller coordination not provided.
- Environmental -40 +40??C, 10 90% RH non-condensing
- Equalization Voltage 15.2VDC Fixed Value (range 10.0 40.0VDC ) automatic Fixed at 2 hours each 30 days, may be disabled (time and day settings variable , or equalize can be manually actuated )
- Auxiliary Output Function Single output field configurable as either: 25 Amp load controller or 2 Amp auxiliary battery charger
- Aux. Battery charge 2 Amp typical, same charge voltage as primary battery
- Load Control 25 Amp maximum; ON @ 12.6VDC / OFF @ 11.5VDC (Range 10.0 40.0VDC ), or net battery amp-hours )
- Temperature Compensation Optional temperature sensor adjusts charge voltage setpoints based on measured battery temperature, -5.00 mV/??C/cell correction factor (Range -0.00 -8.00 mV/C/cell ) sensor range -60 +80C
- Auxiliary Battery Voltage Auxiliary battery voltmeter, 35.0VDC ??0.50% FS
- Communication Complete IPN Network interface. Allows up to 8 IPN capable controllers to set up and operate as a single machine, share a common battery temperature sensor, and share an IPN-Remote or IPN-ProRemote display. Simple twisted pair cable interface with no special communication hardware required.
|
You may also like
|
|
$639.92
|
 |
|
|
$663.93
|
|
|
|
$130.81
|
|
|
|
$212.88
|
|
|
|
$253.50
|
|
|
|
$130.81
|
|
